How To Disable Collision Mitigation System Peterbilt 579 (2024)

FAQs

How to turn off collision mitigation braking system permanently? ›

Press and hold the CMBS™ OFF button. A beep sounds and a message appears in the Driver Information Interface. The CMBS™ indicator appears when the system is off. CMBS™ automatically resets back to ON each time you start the engine.

If you want to turn off CMBS just press and hold down the CMBS button located to the left of the steering column until you hear a beep and a confirmation message displays in the vehicle's Driver Information Interface. CMBS will now be shut down until you turn off the ignition.

The wingman/collision mitigation system is an option. To fully eliminate the system you'd have to replace the ABS controller. These are programmed by VIN. You'd basically have to order a module with a VIN that does not have the system.

The Bendix® Wingman® Fusion™ system audible alerts are pre-set at the factory for fully integrated systems and cannot be turned off by the driver, but, depending on the OE, the volume may adjustable.

The CMBS utilizes a radar sensor in the grille and a front-facing camera located behind the rearview mirror to help detect other vehicles and pedestrians on the road ahead.

You can override automatic braking at any time by pressing the accelerator or by braking; if you don't press the brake pedal soon after the stop, the Electric Parking Brake may be set, which you can release with the Electric Parking Brake button while pressing the brake pedal.

When the CMBS is on, the radar sensor constantly scans for vehicles ahead of you. This means that driving on a road with a few or no vehicles could cause a CHECK CMBS RADAR SENSOR message to appear on the multi-information display. This is normal and not a cause for concern.

Most forward collision warning systems are active by default at speeds greater than 10 mph. You can deactivate the system by pressing the forward collision warning system button or by accessing your forward collision warning settings via your vehicle's information screen.

From the Settings menu, select Driver Assist > Pre-Collision. Toggle Active Braking on or off. With Active Braking disabled, the Ford Pre-Collision Assist will notify you when a collision risk is detected but will not assist in braking to avoid a collision.

Temporarily Disabling the System

The system can be temporarily disabled by pressing the OnLane switch. This disables warnings for 15 minutes. Warnings can be enabled by pressing the OnLane switch again.

How do I turn off CMS on an international truck? ›

To deactivate cruise control

Press the service brake or clutch pedal.

Can You Turn Off Honda Sensing? Yes, you can turn Honda Sensing® features off if you want. To turn off RDM, press the button under ECON. LKAS can be disabled by pushing the MAIN button on the steering wheel.

The complaints allege that the automatic emergency braking system can brake the vehicles with nothing in their forward path, increasing the risk of a crash. The agency said it has 47 reports of crashes and 112 reports of injuries from the problem.